HOME | UPLOAD Pic/Video | MY ACCOUNT | MY PROFILE | LOGOUT

Diagram By: Jason Holland. Reproduction Of Orginal by: Torey Schutte

You'll need one toggle and one pushbutton switch. Take a hot wire directly from your battery and connect that to one side of the toggle then jumper it to your pushbutton. From the switched side of the toggle run that wire to you distributor (back left post) and from the pushbutton run that to your starter ("S" terminal). Run your ground cable from your battery straight to the back of the engine (clean the ground point first) and the positive cable to the starter. Run most of your wires through the hole from the heater core to keep them from being pinched or burned by the engine. You can line them with rubber hose or wrap them with duct tape to help protect them.
 

Disclaimer

©2002 International Demolition Derby Association. All information i.e audio, video, text tutorials or otherwise is the intellectual property of the International Demolition Derby Association. By submitting any information to or through this site. Your agree to give the IDDA the rights to use it in various publications on the site as well as off the site.Any and all submissions to this web site will become the property of the IDDA. We will if possible always credit the author of all submissions whether by text link to web site or via posts of articles with authors name/s. All credit will be under the title (Complements: your name). If you do not agree with this then please do not submit any information . All rights reserved Derbypro.com International Demolition Derby Association. For more detail please read our disclaimer